This post will discuss two scenarios where we can use this type of configuration: in an Enterprise network and a Service Provider network. Router on the stick configuration Scenarios The port on the switch side is configured with an 802.1q trunk link, and on the Router side, there are multiple sub-interfaces, one sub-interface per VLAN. Here switch is a Layer 2 switch with multiple VLANs, and the router has all layer 3 IPs, and it handles all inter-VLAN communication. It is a networking terminology used to represent a layer3 device and a layer 2 switch where a single physical cable directly connects them. This method makes it very easy to add additional equipment to your network without the need to run a direct cable from your user device to the layer3 capable device. The router on the stick configuration is a powerful and easy way to design your network. Service Provide Cisco Router configuration:.Service Provide Cisco switch configuration:.Router on Stick Config – Service Provider Example.Commands to Check if your setup is working properly.Router on Stick Config – Enterprise Example.Router on the stick configuration Scenarios.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |